Several important parts of the car: steering wheel, engine, gearbox, do not pay attention when these parts have problems. The steering wheel is the most intuitive “spokesperson†for auto parts, which interprets the handling performance of the vehicle. At the same time, it also controls the safety performance of the vehicle. It is called the plate of life. When there is a problem with the steering wheel, it must be checked and repaired in a timely manner.
There are many reasons for steering wheel jitter, and look at the following small series for everyone to analyze.
1. Steering wheel jitter at high speed
This situation may be caused by the transmission system of the vehicle. It should be checked whether the positioning angles of the front wheels meet the requirements. For example, the misalignment should be adjusted.
2, when the direction of the steering wheel jitter is serious
This is because the power belt is too loose or too tight. It is mainly for mechanical hydraulic power-assisted vehicles. Adjust the tightness of the belt or replace it.
3, when high-speed step on the brake, the steering wheel suddenly jitter
Excessive braking force and excessive frequency will cause brake discs and brake pads to overheat and cold deformation. At this time, brake discs need to be replaced or polished.
4, suddenly shake the steering wheel of a certain speed segment
During the driving process, the steering wheel suddenly shakes at a certain speed. It is probably because the tire balancing value is not accurate. This will cause the steering wheel to shake within a certain speed range. Deformation of the hub of the automobile tire, incorrect tire pressure, uneven wear of the tire periphery, and improper assembly of the balance weights are the main causes of poor wheel dynamic balance.
5, normal road, pit road will appear jitter
This is due to the fact that when the car is in motion, it is better to go to a professional maintenance point for inspection and replace the damaged parts due to wear and looseness of tie rods or loose rubber sleeves at joints and irregular wear of tires.
The steering wheel shake is a very common fault during the use of the car. Although it is small, it must be taken seriously. Most drivers think that steering wheel shake is a problem in the interior of a car. It is difficult to check and repair and overcomes the need to use it first. Once there is a problem with the steering wheel, do not wait to solve the problem immediately to avoid an automobile accident.
Runde's copper Press Fittings for plumbing and HVAC,design according to park and vigea,M type press fittings,V typePress fittings,Nibco press fittings,vigea press fittings,connex press fittings
press fittings,Copper Press Fittings,copper press fittings,press copper fittings,M type press fittings,V typePress fittings,Nibco press fittings,vigea press fittings,connex press fittings
Taizhou Runde Company , https://www.zjbrassfittings.com