The suction pipe should also be placed outdoors when designing the injection screw air compressor compressed air station. The practice is as follows: (1) A rubber plate of the same size and a thickness of about 1020 mm is placed on the air inlet of the air compressor, and a flange of one end of the suction pipe is placed on the rubber plate. (2) The other end of the suction pipe extends out of the outdoor suction muffler. At this time, measures should be taken to prevent rain and debris.
Determining the reasonable compressed air dew point The temperature at which the humid air cools to saturation at a certain pressure is called the dew point. When the air temperature reaches the dew point, water droplets are deposited. Water droplets in the air can affect product quality or equipment operation. Modern industry has requirements for the compressed air dew point used. In order to reduce the dew point of the compressed air, it is necessary to consume the already compressed compressed air or electric energy, thereby consuming energy and increasing the production cost of the enterprise. The heat-free regeneration process produces dry compressed air. The amount of dry compressed air consumed by the regenerative desiccant is about 13% of the air volume. The electric energy consumption of the dry compressed air produced by the freezing process increases with the decrease of the dew point. The lower the dew point, the lower the dew point. The more expensive, the more expensive the equipment you need. In order to reduce the project cost and save energy, the compressed air dew energy saving point should be determined in different situations.
According to the process requirements, certain industries, such as medicine, electronics, high-purity materials, etc., are used for agitation and product purging. For the control of product quality, low dew point compressed air is required, and the required dew point can reach -40-70e ( Atmospheric pressure). The compressed air dew point at this time should meet the process requirements.
An anchorage frame secures the Tower Crane mast to a structure or framework and provides stability when the tower crane is under load or experiencing wind forces. The number of Tower Crane Anchorage Frame is calculated by taking into account such factors as the type of tower cranes, jib length, height under hook, and maximum out-of-service wind speed.
Jacking Part Anchorage Frame,Tower Crane Anchorage Frame,Mast Section Anchorage Frame,Anchorage Frame For Tower Crane,Tower Crane Anchor
SHEN YANG BAOQUAN BUSINESS CO., LTD , https://www.syconstructionhoist.com