Intelligent swing gate wiring manual

The requirements, confirmation, design, production and installation of the pedestrian passage gates are very critical. Beijing Simolo has paid attention to every detail as a manufacturer. Today, it is only possible to swing the wiring to go into detailed instructions. It is very helpful for the manufacturer and integrators installed by the manufacturer. After all, the personnel who often do the gate project can understand that the actual wiring error will cause the intelligent swing gate to be unstable or unable to operate. Will cause damage to the gate.

Intelligent swing gate wiring manual

1. Generally, the expansion bolt can be fixed on the swinging base of the pedestrian swing. If a simple set of intelligent swing gates is installed, it is necessary to connect a power cord to the internal controller of the swing gate, and then fix the swing gate, and normally swipe the card. The pass test is OK. But the specific operation still has to pay attention to many problems.

Second, wiring: According to the design drawings on-site measurement, to the swing gate positioning;

After the installation swing position is fixed, draw the mark in advance, start to dig the line to bury the power line pipe, thread the line into the tube, and connect the swing gate system protection ground wire.

Third, UPS assembly

Fourth, the intelligent swing gate fixed: then the pedestrian gate is fixed, the gates of the left and right swing gates of each channel should be aligned, and test whether it is on a horizontal line.

V. Installation, power-on commissioning test equipment access, after completion, the dug line is sealed with cement!

Intelligent swing gate wiring manual, explain in detail the paper description in the Ximo Luo gate delivery list and the gate chassis, for other problems that do not understand the swing gate gate three roller gates, etc., you can pay attention to the face at any time. Identify the brake manufacturer Beijing Simolo.